A manutenção do centro de perfuração e tapping de três eixos inclui principalmente os seguintes aspectos:
Regular cleaning: The drilling and tapping center will accumulate a lot of dust and cutting fluid residue during long-term operation, which will affect the heat dissipation and precision of the equipment. Therefore, the equipment should be cleaned regularly, including the body, guide rails, workbench and other parts. When cleaning, special cleaning agents and soft cloth should be used to avoid using highly corrosive cleaning agents or sharp objetos para arranhar a superfície do equipamento .
Lubrication and maintenance: Lubrication is an important part of the maintenance of the drilling and tapping center. The lubricating oil and grease inside the equipment should be checked and replaced regularly to ensure that all parts can operate smoothly. At the same time, the pipelines and joints of the lubrication system should also be checked to see if they are intact to avoid oil vazamento .
Fastening inspection: When the drilling and tapping center is in operation, the various components will be affected by vibration and impact, and are prone to loosening. Therefore, the fasteners of the equipment should be checked and tightened regularly, including screws, nuts, pins and other parts. During the inspection, special tools should be used to ensure that the fasteners reach the specified tightening torque .
Electrical system inspection: The electrical system is the core part of the drilling and tapping center, and its stability and safety are directly related to the operation of the equipment. The electrical system should be inspected regularly, including power cords, motors, controllers and other parts. During the inspection, attention should be paid to checking whether the wiring of the electrical components is firm, whether the motor is running Normalmente, se o controlador é exibido normalmente, etc .
Daily inspection: In addition to the maintenance and care of the above aspects, a daily inspection system should also be established. Before starting the machine every day, a comprehensive inspection of the equipment should be carried out, including lubrication conditions, fastener status, electrical system conditions, etc. Problems should be dealt with in a timely manner to ensure that the equipment can operate normally.
Detalhes de outros detalhes de manutenção:
Air Source Cleanness: verifique se a fonte do ar está limpa para evitar o vapor de água excessivo no tubo de ar, causando ferrugem nos componentes da válvula de controle .
Manutenção de acesso: mantenha o oleoduto desobstruído, verifique regularmente se o tubo de ar e o tubo de água têm vazamento ou dobragem e verifique se os parafusos da placa de pressão de cada acessório estão apertados .
Timely chip removal: Clean up the accumulated chips regularly to prevent external switch failure. Pay attention to abnormalities: Observe the machine carefully before handing over or leaving get off work to see if there are any abnormalities, such as the sound of the spindle rotating, tool changing action, etc. If any abnormality is found, stop the machine immediately for inspection and Tratamento .
